Common Rafter Calculator
Gable-roof common rafters: plumb-to-plumb length, ridge board deduction, birdsmouth angles, overhang tail, and total board length.
Single-slope instead? Shed roof calculator · Hip or valley ends: hip rafter calculator
Building & Roof Inputs
ft
2× ridge = 1.5" · built-up = 3"
in
Geometry used: run = (span − ridge) ÷ 2 · theoretical length = run × √(1 + (rise/12)²) · ridge shortening = (ridge ÷ 2) ÷ cos θ · tail = overhang ÷ cos θ.
Cut List
6:12 · 26.6°
13' 3 1/4"
Plumb-to-Plumb Rafter
13.28 ft
14' 4 5/8"
Total Board (with tail)
order 14.39 ft lengths
0.84"
Ridge Deduction
1.5" ridge ÷ 2 ÷ cos
26.6° / 63.4°
Seat / Plumb Cut
birdsmouth angles
Run per side (span − ridge, halved)11' 11 1/4"
Total rise (to ridge, above plate)5.97 ft
Rafter tail (overhang along slope)1' 1 3/8"
Common Rafter Cut Sheet
| Cut / Dimension | Value | Notes |
|---|---|---|
| Plumb cut (at ridge) | 63.4° | Speed square set to the pitch, cut vertical |
| Seat cut (birdsmouth) | 26.6° | Rests on the wall plate; keep depth ≤ ¼ rafter depth |
| Ridge deduction | 0.84" | Half of ridge thickness ÷ cos(26.6°) |
| Theoretical length | 13.35 ft | Birdsmouth plumb line to ridge centerline |
| Total board | 14' 4 5/8" | Plumb-to-plumb + 1' 1 3/8" tail |
Keep the seat cut to ¼ of the rafter depth (2x6 → ≤ 1⅜") so the height above plate stays strong. HAP (height above plate) is what remains above the seat — keep roughly 3 in minimum on dimensional lumber, and always test-cut one rafter before cutting the set.
Related Roofing Tools
Frequently Asked Questions
Rafter length = run × rafter factor, where run is half the span (minus half the ridge thickness) and the factor is √(1 + (rise/12)²). A 24 ft span at 6:12 with a 1.5 in ridge: run = 143.25 in, factor 1.118 → about 13.35 ft plumb cut to plumb cut.